Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
tahreg
 Post subject: Coax connector ends
PostPosted: Sat Aug 01, 2015 12:37 am 

Joined: Sat Aug 01, 2015 12:28 am
Posts: 1
I have lots of coax connector ends
What are they made of ?
Does Boardsort accept them.

Thanks


Attachments:
ppc.JPG
ppc.JPG [ 6.98 KiB | Viewed 3751 times ]
rg6-f-connector.jpg
rg6-f-connector.jpg [ 13.59 KiB | Viewed 3751 times ]
Top
 Profile  
 
lostinlodos
 Post subject: Re: Coax connector ends
PostPosted: Sat Aug 01, 2015 9:17 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10042
Location: Low DOS
Boardsort doesn't take them
Use a small magnet
If it sticks it's steel
If it just sorta sticks or does the roll along thing it's stainless

And if it doesn't stick at all (i use a hard drive magnet to be sure) it's probably nickle or chrome plated brass, or magnesium.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: