Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Sat Mar 21, 2026 1:46 am

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 2 of 2
  [ 14 posts ]  Go to page Previous  1, 2
  Previous topic | Next topic 
Author Message
rdw1121
 Post subject: Re: shielded ram
PostPosted: Wed Feb 19, 2020 8:27 pm 

Joined: Fri Jul 01, 2016 6:55 pm
Posts: 750
Location: Texas
Yeah 316L is a little pricey, I sell quite a bit of 316L flanges, fittings and valves to a major oil and gas company.
Duplex is higher and then you get in to the “exotics” alloy 7, 11 inconels, monels and etc....lol
I just quoted them a 3-1/8 5000# API flange made out of inconel 825 our cost was $4500.
Top
 Profile  
Reply with quote  
lostinlodos
 Post subject: Re: shielded ram
PostPosted: Wed Feb 19, 2020 10:57 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10219
Location: Low DOS
I was more if the idea of this.
Attachment:
9AEB76E9-4D12-4CE5-8CD4-0A7CEAEA7EF4.jpeg

Which I use for both high temperature solder work and acid testing.


You do not have the required permissions to view the files attached to this post.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
Reply with quote  
AAK2
 Post subject: Re: shielded ram
PostPosted: Thu Feb 20, 2020 8:45 am 

Joined: Thu Aug 01, 2019 6:55 pm
Posts: 556
Floppy or zip drive magnet?
Top
 Profile  
Reply with quote  
lostinlodos
 Post subject: Re: shielded ram
PostPosted: Thu Feb 20, 2020 3:53 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10219
Location: Low DOS
Neither. That from a respool unit for 60mm film. Part of the lifter. It’s the magnet inside the motor.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 14 posts ]  Go to page Previous  1, 2

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: