Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Wed Apr 01, 2026 8:09 am

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
tahreg
 Post subject: Coax connector ends
PostPosted: Sat Aug 01, 2015 12:37 am 

Joined: Sat Aug 01, 2015 12:28 am
Posts: 1
I have lots of coax connector ends
What are they made of ?
Does Boardsort accept them.

Thanks


You do not have the required permissions to view the files attached to this post.

Top
 Profile  
Reply with quote  
lostinlodos
 Post subject: Re: Coax connector ends
PostPosted: Sat Aug 01, 2015 9:17 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10239
Location: Low DOS
Boardsort doesn't take them
Use a small magnet
If it sticks it's steel
If it just sorta sticks or does the roll along thing it's stainless

And if it doesn't stick at all (i use a hard drive magnet to be sure) it's probably nickle or chrome plated brass, or magnesium.
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: