Post new topic Reply to topic  Page 1 of 1
  [ 4 posts ] 
  Previous topic | Next topic 
Author Message
escrap16
 Post subject: printer board?
PostPosted: Mon Jan 25, 2016 3:54 pm 

Joined: Wed Jun 17, 2015 9:57 am
Posts: 43
Location: South Plainfield nj
go these out of a dell printer. is it worth it ?


Attachments:
File comment: where would these go?
20160120_210604.jpg
20160120_210604.jpg [ 1.29 MiB | Viewed 4123 times ]
Top
 Profile  
 
lostinlodos
 Post subject: Re: printer board?
PostPosted: Mon Jan 25, 2016 4:35 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10050
Location: Low DOS
Real long board is probably mid grade. Rest are peripheral
Top
 Profile  
 
jessad1983
 Post subject: Re: printer board?
PostPosted: Sun Jan 31, 2016 8:01 am 

Joined: Mon Jul 28, 2014 7:26 pm
Posts: 85
The square one is peripheral, the other two are mid, the long one because it has no ic pop, the other because there is no ic pop, and there appears to be a heavy component on it. But I'm positive on my grade.
Top
 Profile  
 
lostinlodos
 Post subject: Re: printer board?
PostPosted: Sun Jan 31, 2016 9:07 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10050
Location: Low DOS
That component looks like a gold pin card slot. Which is why I put it in peripheral class, much like floppy controllers.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 4 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: