Welcome to Boardsort™ - Learn - Sell - Profit -

I’ve got about 25lbs of RAM with heat shields. Two questions:

1. Is apply some amount of heat the best way to remove them as to not damage the chips? At this scale I’m not sure how practical that might be.

2. Is it ALWAYS best to remove all shields or in the case of particular large/heavy/bulky shields does the math typically work out better to keep it on?

You’ll never earn more per pound leaving the shields on.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D

I have a bunch with EXTREMELY heavy heatsinks (2.7oz per stick) so I’m not sure your absolute is accurate.

But to my other question on removal…cause thus far almost or all chips are getting pulled off the sticks when just popping cold with a screw driver…that kind of damage is gonna hurt my rate more than anything

Almost, there’s always exceptions to every rule

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D

Many suggest freezing. I’ve always had better luck with a heat gun myself. But I can understand issues with quantity so attempting freezing may be worth while.
It depends on the type of paste used to attach the spreaders.


I’m intrigued by your heatsink size claim. Any chance you could post a picture?

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D

Yeah I’ll post some pictures in a bit when I get back to the office. They are thick like extruded motherboard heatsinks - and on both sides.

I've run into copper heatsinks a couple times... ¯\_(ツ)_/¯

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort

chunky!

They have clips so you have the advantage of taking them apart and weighing all the bits to confirm pricing and then put it back together if it's more cost effective.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort

Ah, like dominator

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D