Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
hollywood
 Post subject: Grading help please
PostPosted: Mon Apr 11, 2016 10:10 pm 

Joined: Sun Aug 17, 2014 8:17 pm
Posts: 17
Hey everyone... been a long time. Getting a shipment ready and I've got it all nailed down except for these guys... any help grading these would be greatly appreciated. On the last one, should I try to get the voltage regulator off because of the aluminum? That heatsink is ON there (not screwed on - figures, right?) I'd probably have to take the entire regulator off, but I wasn't sure about degrading the board... Thanks in advance for your input!


Attachments:
File comment: Backs
20160410_193612.jpg
20160410_193612.jpg [ 1.06 MiB | Viewed 3190 times ]
File comment: Fronts
20160410_193557.jpg
20160410_193557.jpg [ 1 MiB | Viewed 3190 times ]
File comment: Front and back
20160410_193520.jpg
20160410_193520.jpg [ 1.05 MiB | Viewed 3190 times ]
Top
 Profile  
 
lostinlodos
 Post subject: Re: Grading help please
PostPosted: Mon Apr 11, 2016 11:34 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10050
Location: Low DOS
The set of three will all be telco.
That large one will get large socket or telco. Not 100%
Top
 Profile  
 
hollywood
 Post subject: Re: Grading help please
PostPosted: Tue Apr 12, 2016 12:04 am 

Joined: Sun Aug 17, 2014 8:17 pm
Posts: 17
Thanks very much!
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: