|
Pull those wire ends.
1/3 high peripheral
4 low peripheral at least, might be okay in high
On 2, get a small flathead (or similar) to press into a corner (or if there's a break in the solder) to get under the shield and pry up or use a pair of cutters to crimp into a corner and pry up. Try to be careful as you do this as there should be higher value components under there that benefit from having shielding. If the antennae in the corners of the board are steel, remove those while you're at it and then repost a picture
_________________ Here to learn more so I can recycle more My grades are my own opinion and not an official grade from Boardsort
|