Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
Thorgate
 Post subject: High grade board?
PostPosted: Tue Nov 25, 2025 1:53 am 

Joined: Sun Nov 02, 2025 4:44 am
Posts: 2
Are these high grade boards? And what would they be if i took the ic chips off what grade of board would they be?


Attachments:
20251123_183323.jpg
20251123_183323.jpg [ 2.48 MiB | Viewed 553 times ]
Top
 Profile  
 
marked141
 Post subject: Re: High grade board?
PostPosted: Tue Nov 25, 2025 9:37 am 

Joined: Sat Nov 29, 2014 9:44 pm
Posts: 1463
Location: I'm right here :D
Pull all the batteries! I see one on each of the four top boards but be sure the other two don't have any either.

The three larger boards on the left should be okay. If you're pulling the ICs do remember that could result in a lower grade, but again the three left should be okay.

The right three might clear low Telco or, since there are gold fingers, clean gfc.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: