All,

I'm looking for help categorizing two different boards with and without the shielding. I have a bunch of these and most of the shielding on the boards is just a pain to remove. It's so much of a pain that depending on how big a hit there is financially to leaving them on I may just send them in as seen in the photos below with the shielding on.

(I made another post in How To's, Tips & Techniques about how difficult this specific shielding is to remove and asked for ideas on how to remove it more quickly/easily. If you have ideas I'd love to hear them there or here.)

If it matters or helps with categorizing, both of these types of boards were attached to a larger mainboard in a Cisco WAP.

I replied in your other post. I have several of those same boards and hoped they would fall into High Grade Telecom, but I'm not sure. The best method for me is a small sharp putty knife (see other post for more info).