Welcome to Boardsort™ - Learn - Sell - Profit -

I have a couple of these large boards that are clearly wire-wrap one one side, and on the other side are many connectors loaded up with gold pins. Would this whole thing go as wire wrap, or would I have to remove all of the gold-pin connectors on the other side? Or, could the whole thing go as pin board? (photos 1 and 2). Wires will be trimmed short, but not unwrapped.

I also have a number that don't have the wire wrap pins on one side. Would these go as backplane? (photos 3 and 4)

The plastic brackets look to be removable on some, and I assume the pins stay put. Do I need to remove those?

Thanks!

Remove the bulk of the loose wire and it’s good as is. Wire wrapped pin board.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D