How would this board grade? TiA!

Nothing on the back?

I'm thinking high peripheral.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort

No, nothing on the back. Thanks for the input.

First of all. I am learning Escrap. But a tear down of your board is an option. A tear down as I understand so far from the forum. Your PCB seems to make more money than the individual submission. So my view of a tear down on your board is as follows.
. Desolder or cut off all connectors. I can't resist. I used to assemble that same connector. That is gold pin. Thru and thru. Remove the Dip Switch and other edge connectors. All those will go Connector Ends. Take the IC chips from the sockets. Of course. For them. IC Chip Category. Then you have Low/ Midgrade. If even Boardsort will buy it. It is just populated with resistor network stuff. Good luck.
That's my novice evaluation.
My evaluation advice is my own opinion.
Here to learn like everybody else.

What are these

First post, High Per, but I believe it could push Low tel because those connectors are great although bulky but paired with all the ICs, it's a fair argument for Low tel; being fair High per. Those connectors can be silver plated Cu, Brass, too.

Board 1, High per

Board 2, High per; now... being a fair and genuine person that I am, I would remove all those screws from the input stands. Hardware, if not always, is ferrous material; steel. Steel in unwanted on the PCBs. Even though, that would be something of steel nature that's looked over. I choose to do it to make the recovery processes better.