Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
XionXero
 Post subject: Did i mess up??
PostPosted: Thu Jun 12, 2025 1:35 pm 

Joined: Thu Jun 05, 2025 9:41 am
Posts: 2
So i found this processor and in trying to grade it i put it as AMD ceramic (no metal)... so i tried removing the metal and ended up pulling part of the chip out with the metal. Do i try putting the chip back with the pin board? How should i proceed, and is my grading correct?


Attachments:
image000002.jpg
image000002.jpg [ 229.6 KiB | Viewed 297 times ]
image000001.jpg
image000001.jpg [ 219.63 KiB | Viewed 297 times ]
image000000.jpg
image000000.jpg [ 195.37 KiB | Viewed 297 times ]
Top
 Profile  
 
ropeman
 Post subject: Re: Did i mess up??
PostPosted: Thu Jun 12, 2025 2:28 pm 

Joined: Tue May 14, 2019 11:09 am
Posts: 736
Put it back together, wrap some tape around it and send it as P4/Green Fiber With Metal. Same thing I do when the heatsink comes off a board with the IC still attached. As long as both parts are together it shouldn't be downgraded.
Top
 Profile  
 
Spence1015
 Post subject: Re: Did i mess up??
PostPosted: Sat Jun 14, 2025 4:01 am 

Joined: Fri Dec 20, 2019 3:16 am
Posts: 244
Location: Ohio
^
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: