Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Sun Mar 22, 2026 5:37 pm

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
Catwhisker
PostPosted: Sat Mar 21, 2026 1:14 pm 
User avatar

Joined: Mon Apr 15, 2024 9:38 pm
Posts: 362
Location: Western Pennsylvania
I came across about 60 shielded Gold Fingered Ram. Note. I keep the hot air gun on. And use it 95% of the time. Some shields will fall off after removing supporting clips. But. Not always. Of course. There is a myriad of "substances" used to "secure" contact between the heat sink and the ram. The glue. The glue strip. Etc. Remains on the ram board. It is close to stupid to try and remove it. Am I ok. Just submitting Gold Finger Ram with that residue?
Here to learn like everybody else
Top
 Profile  
Reply with quote  
lostinlodos
PostPosted: Sat Mar 21, 2026 3:05 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10222
Location: Low DOS
As long as all reasonable attempt was made to clean it yes.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: