Hello there,
I have encountered the following problem with one of the boards I pulled out of one of those razor thin servers. This seems to be a peripheral card but there is a metal cage right on top of it which seems to be soldered to the card. I have been trying to separate the metal cage from it but I am destroying the card. I also see 2 separate tiny gold finger cards attached to the metal cage but, yet again, I can't manage to separate them. Do you think Boardsort will get upset if I send it as a peripheral card with the metal cage on it?
Also, I was wondering if you could help me identify a few more cards.
Thanks a million!
Kindly regards, Natalia
Attachments: |
File comment: Board identification Bottom Side
Peripheral B.JPG [ 1.93 MiB | Viewed 3685 times ]
|
File comment: Board identification Front Side
Peripheral A.JPG [ 2.12 MiB | Viewed 3685 times ]
|
File comment: Board identification Bottom Side
Boards B.JPG [ 2.26 MiB | Viewed 3685 times ]
|
File comment: Board identification Front Side
Boards A.JPG [ 1.98 MiB | Viewed 3685 times ]
|
File comment: Peripheral board with metal cage issue
Metal Cage 4.JPG [ 1.47 MiB | Viewed 3685 times ]
|
File comment: Peripheral board with metal cage issue
Metal Cage 3.JPG [ 1.37 MiB | Viewed 3685 times ]
|
File comment: Peripheral board with metal cage issue
Metal Cage 2.JPG [ 1.63 MiB | Viewed 3685 times ]
|
File comment: Peripheral board with metal cage issue
Metal Cage 1.JPG [ 1.59 MiB | Viewed 3685 times ]
|
|