Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 7:42 am


Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Nov 25, 2018 9:48 am 

Joined: Tue Jun 19, 2018 4:52 pm
Posts: 129
Attachment:
IMG_4321.JPG
IMG_4321.JPG [ 1.86 MiB | Viewed 5122 times ]
Attachment:
IMG_4322.JPG
IMG_4322.JPG [ 2.17 MiB | Viewed 5122 times ]
Attachment:
IMG_4320.JPG
IMG_4320.JPG [ 2.43 MiB | Viewed 5122 times ]
Is this one ok as is, or should the huge plastic connectors come off then clip the flat "pins"?
I keep forgetting to post the photos in reverse order. First photo above shows the large flat gold flashed connector with the plastic removed. Second is end view of terminals.
bottom photo is the board. about 3 inches wide and a foot long, with not much on it other than the capacitors.


Top
 Profile  
 
PostPosted: Sun Nov 25, 2018 4:56 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
As is it’s peripheral. Any cutting is going to lesson the grade. I can’t tell if the pins will make up for midgrade but I doubt it.
Leave this one be.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: